Folks,
This may have been discussed before. First time posting on the forum.
I have a 550B with the case feeder. All alignments have been looked into twice. My problem is with the priming station. I feed brass in and deprime. When I go to back stroke to seat a new primer,the brass moves out slightly. I have to double pump (short strokes) the handle to get it back over center or move it by hand. Most times I have to move it by hand. All screws are tight and the primer cap is centered the hole on the shell plate. I hear from FB sites that this is a problem on a 550B with the Case Feeder. There is no clip to hold the brass in place anymore as is w/o case feeder. Any help would be appreciated.
