Tubguy

i need a rule clarification..... I have a 320 max for carry optics. It looks like I can keep the factory mag well that came on the gun. Am I reading this right? I don't want to get bumped to open.

Thank you

Is it legal to put a thumb rest on a carry optics Sig 320 x-5

Primer slide has been polished and slides like glass.

Thats not the issue here. I've had the shell plate out several times. It indexes fine for a couple of rotations then for no reason will skip one index. And not on the same index hole in the .shell plate

I have a Revolution that has shell plate issues. On almost every complete shell rotation. The shell plate will not advance. The tool head goes down again and adds another powder drop to an already filled case. Yep, powder all over the place. I have had the shell plate out twice and can't seem to see any issues with the plate. I noticed the rotation pawl is spring loaded and seems to be fine. It looks like it retracts far enough to grab the index hole in the shell plate to turn the shell plate. I have the large nut tight so there is no side to side movement across the plate. Any ideas? TIA Mike

Thanks Guys i just ordered one.....

I'm looking for a dust cover for my SRO. I'm not finding anything at the usual sources. Has anybody found one? TIA Mike

Where did you purchase it from? can you provide a link?

Besides the Dillon case feeder, which case feeder is most trouble free. You know jam proof. I want to run one on my roll sizer. thanks.

So I'm looking in my parts manuals for the 1050 and 650 and they have different part numbers for the powder measures. 650 #20872 1050 #20421 Any body now what the difference is? Mike

I’m just wondering if anybody has tried a non Dillon powder measure on their Dillon press? It looks like the new Mark Vll is not using a Dillon powder measure. I’m not experiencing any problems, just thinking. Mike

Is there a way to remove the primer tube assembly from a 1050, with primers in the tube, and not get primers all over the place? Thanks

Broncman so which brand of drill bit did you use. Was it a carbide bit. Also, did use a standard tap? Thank you

I like that small blast cabinet. Who makes it and or where did you buy it.

Do you have a sand blaster recommendation?

I was wondering if anybody is using small sand blasters to remove lead and keep the inside of the comp spotless Mike

Grams springs and followers here too

I'm working up a 9mm major load for shooting open. I'm using Hornady 115 grain bullets. I'm looking for a recipe for a starting point. using CFE powder. Thanks Mike

I have a open pistol and would like to get a gun rug for open pistol. What is everyone using? i have one that came with the gun but it's a little small/tight. Looking for ideas.

^^^^^^ All that info is ^^^^^

I am only able to feed 5-7 bullets into the mag before something inside the mag prevents anymore bullets from being loaded. OAL length is not an issue.

Im new to open. I have 170mm tubes with, I think are STI. grams springs and followers. There is also a spacer in the mag. Shooting 9Major. Loading the bullets into the mag seems to hang up only after putting in a few rounds Tried bumping the mag to free up what ever is going on but it does not seem to remedy the condition. Any ideas on what I should be looking for inside the mag? Thanks Mike

Thanks i think I was applying to much heat.

It seems every time I replace the fifer it not very bright. I'm not sure if this is normal or am I doind something wrong.