Jump to content
Brian Enos's Forums... Maku mozo!

IntenseImage

Classifieds
  • Content Count

    922
  • Joined

  • Last visited

About IntenseImage

  • Rank
    Calls Shots

Profile Information

  • Gender
    Male
  • Location
    Northampton, PA
  • Real Name
    Brian Daku

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I don't but Ive let others use the mag in their VR80s at matches. At this point the VR80s are well outnumbering the VEPRs [emoji41] Sent from my SM-G975U using Tapatalk
  2. If you plan and shoot to it that CH never even comes into play. My 28 runs all day long and in multiple guns ... Talk to Tooth if yours doesnt Sent from my SM-G975U using Tapatalk
  3. Thanks ...Cleaned it well and it basically ran since day 1 even using 1200s. 100rds of 1300s are my base recommendation. The Taccom buffer helps too Sent from my SM-G975U using Tapatalk
  4. 2 shooter, 1 VR80 I was 1st Open (of 21) and High Overall (of 70) Sent from my SM-G975U using Tapatalk
  5. Elftmann and CMC were supposed to be working on them Sent from my SM-G975U using Tapatalk
  6. Per Josh: Sorry for the delay. Been dealing with some health issues with my youngest son. Been meaning to send out an email to everyone who has pre-ordered with an update. So after talking with a few customers who ordered some of our other triggers we have found some slight variation in the distance between the hammer and trigger pins. This has caused a few guns to allow the hammer to miss the trigger dear upon reset. We had to cancel our EDM and redesign the geometry slightly to account for this difference. This has added some time to the process because of the change. I am supposed to have a new eta later this week. Sorry for any inconvenience. I am hoping to be back in the shop full time tomorrow and will get an email sent out to all the pre-order customers. Sent from my SM-G975U using Tapatalk
  7. Dissident Sent from my SM-G975U using Tapatalk
  8. Just have em swap if you have tried some troubleshooting already Sent from my SM-G975U using Tapatalk
  9. Bend some kydex and make a shield, use thermal wrap, modify some Mlok panels ...
  10. Got u pumpkin Sent from my SM-G975U using Tapatalk
  11. No but they said they would replace them if they don't work. Try loosening the clamp a bit, stuff it full, then snug it back down. It's just an alignment issue Sent from my SM-G975U using Tapatalk
  12. It's a rough guess ....last match I believe it was an 18" circle @ 100 ... Held center and got bottom edge hit Sent from my SM-G975U using Tapatalk
  13. 6-8 low @ 100 Sent from my SM-G975U using Tapatalk
  14. Coated lead ... Haven't grouped at 100, but have shot that far in matches Sent from my SM-G975U using Tapatalk
×
×
  • Create New...