prebancolt

I have this problem occasionally, but its usually related to the wire rising up too high. I seat it deeper and the problem usually goes away. J

Pull it, fire the primer/empty case, then trash it. J

550 on left end of table. 1050 on left front. 650 in the middle. Lee turrent on right side. Lee Classic single stage press on another table. 1050 and 650 with bullet feeders and tubes for collecting completed rounds under the table. J

Bullet feeder Completed round through tube into bin under table. Shellplate bearing kit Spent primer upgrade

Yes, you can retain the powder check. And yes, setting the seat/crimp correctly is harder than individually, but once set, it works fine. I've loaded tens of thousands of 9s, 40s, and 45s including lead this way.

Not sure I'm completely understanding what you are describing, but make sure the random cases don't have junk in the grove stopping the cases from being fully inserted. I've also noticed that after cleaning and lubing, the case slide somehow gets grease on the face and drags the case back out of the shell plate. Took me a while to figure out why and how the cases seemed to "jump back out".

Manny Bragg. Top notch.

I just had this exact issue happen to me and this is how I fixed my problem: Remove the shell plate and primer assembly. Pay close attention to the position of the oval piece of metal that is partially covering the bottom of the disk. I didn't realize it, but when I was changing from large to small pistol primers, I didn't tighten the oval piece exactly centered between the holes in the primer disc. The slight amount that it was off was enough to not let the primers drop the way they wanted/needed. I centered the piece and instantly, all was well.... Hope this helps. J

Manny Bragg. Absolutely Love it.

Same Here, I've Never Had To Sort Any Of My Brass And Ive Never Had One Bulged So It Wouldnt Chamber

Same Here, UPS Rocks, FedUp Sucks And Lies About Delivery Attempts.

I left the pedal on the STI Eagle unfinished after bead blasting it. The rest part is just bolted on and the back is relieved just a bit to clearance the slide. I decided to try it that way since it was quicker to make with the parts I had in the shop. If I have problems with it not holding up, I'll just make it out of solid stock. So far, though, the rest has been rock solid and I think it's gonna be ok. I'll try to take some more pics if you want, but it might be a little while, I'm working a lot. I posted this from my computer so I wouldn't kill any more kittens since my Smartphone decided to start capitalizing every word when posting on this site. I personally didn't mind since I hate cats, but some people get offended easily.

I Finished One Using Black Gunkote. It May Seem Like The Gas Pedals Are Mounted Way Back, But You Really Need To Feel A Gun With One On It, Then Shoot It. You Wont Want To Go Back. Imagine Sitting In A Recliner With Your Legs Unsupported In The Air. Now Put A Stool Under Them. That's How I Feel Now After Shooting With The *thumb rest [generic]*. In Addition To Supporting Your Left thumb And Providing Recoil Management, The Pedal Also Makes The Gun Easier To Steer Or Control Left To Right. You Always Think That Your Gun Is Solid Left To Right Until You Try The *thumb rest [generic]* And You Realize You Have Even More Control. I Really Cant Say Enough About It. It's Working Great For Me And Everyone Else I Personally Shoot With Who Has it.

I Would Hate To, But I Think I Would Tear Down The Loads. I'm Guessing Around 3.7-3.8 Gr Will Be Minimum ToWhere You Want To Be.

Almost Forgot, I Also Love 700X For 9Mm Subsonic Rounds 124Gr And 147Gr. 700X Is Fast Burning, So It Makes For Pretty Quiet Loads.