shuter

Great info; thank you!

Good info...I have the Dillon RT1500 trimmer set up on one of my 550 toolheads now, and use the 600 Super Swage on and Inline Fab adapter as well. Sounds like the 1100 can be set up to size, trim, swage and load complete rounds without having to change anything out or do anything separately?

Thanks. Yes, I would definitely want the casefeeder for the 750; should've mentioned that.

Sorry to resurrect an old thread, but the comment, "The 750's sweet spot is only one or two calibers (neither being 223)" obviously has me wondering what's wrong with running .223 on a 750? I have an old 550B and was considering the 750 for a .223/9mm combo press. Any comments much appreciated!

Thanks. I'm a big Dawson fan, so I think I'll get some from them. Appreciate your advice.

Are 2 spare mags enough, generally? 52 total rounds? Or do I need to count on having to put a 3rd pistol pouch on my belt? Thanks

Is there an "adapter plate" sold by someone to put ELS/QLS receivers on Tek-Lok units? My holster, pistol mag pouches, and rifle mag pouches all have tek-loks. Would I be better off just getting "adapters" (if available) and putting them on my ELS belt setup that way?Thanks You don't need adapters for the ELS brackets to fit on Tek-Lok equiped pouches, etc. They just bolt on, hole spacing is the same. Thanks. I guess I'm confused. The above reply said to use tek loks "to secure the receiver to the belt and put the forks on whatever you're trying to attach." That made me think I would clamp my Tek Loks over the ELS belt, then put ELS brackets on the Tek Lok receivers, which would allow me to snap on/off using ELS but be able to move around on the belt by unsnapping the Tek Lok receivers and sliding, etc. Is this right? Sorry, but I probably used way too many words there!

Is there an "adapter plate" sold by someone to put ELS/QLS receivers on Tek-Lok units? My holster, pistol mag pouches, and rifle mag pouches all have tek-loks. Would I be better off just getting "adapters" (if available) and putting them on my ELS belt setup that way? Thanks

Also, are there any downsides to having a mag extend out past muzzle? I have the 22" JM Pro, so a 10 rd RCI tube will extend a good couple inches past.

So, this would apply in any match that limits you to 8+1? I can just plug my 10 rd tube?

Shooting in Oregon. Can I install an RCI 10 round tube but only load 8 and be okay?

Guys, Can I run a 10-rd tube (RCI) on my 930 JM or is there an 8+1 max allowed for shotgun in Tactical? Thanks

Thanks. Is it a bad idea to leave off the clamp altogether?

Is it common for the mag tube to have to be forced into alignment with barrel when reinstalling barrel/tube clamp? Seems like mine is under quite a bit of pressure when clamp is installed. Haven't checked poi yet clamped vs. unclamped. Thoughts? Is the clamp necessary? does it cause issues to have the barrel/mag tube essentially pulling away from each other? Thanks!

Just got the chance to shoot my 930 JM Pro for the first time after having the lifter welded. It worked perfectly before (stock lifter), but now, occasionally, will have a fail to feed. the shell hangs up on the lip of the chamber/barrel. A tug back on the charging handle, or pushing on the shell takes care of it, driving the shell into the chamber every time. Can the "longer" lifter be pushing the shell a tad too high? This happened with all three of the same ammo types that worked 100% prior to welding. Any help would be greatly appreciated. shuter