dtuns

I shot a level 2 10 stage match this weekend and just decided to clean my gun and when I pulled slide off discovered trigger bar broke. Found out hard way not the same as stock trigger bar. Put back together with stock trigge bar and trigger wouldn't release sear so I had to lock slide back and remove firing pin to get apart.

I've got 800 rounds through mine after about 200 these four screws were loose and had a jam not seating primers cause the linear bearings slide down and priming pin was on tilt. Tighten up and back in business. If Ihave any more loose screws might take everything a part and retighten everything. Seams to be lots of people having stuff come loose like when they assembled at factory was just put together hand tight.

Is your shell plate indexing lining up with swage rod and primer rod where is it getting crushed?

I'm getting just under an inch with this load and the hornady bulk 55 boat tail with canalure.

Motors with brushes spark around the brushes when they run.

Probably the electric motor on the feeder.

Scary. I put cases in large ziplock spray then close and mix then open bag so they can dry

Powder valley has CCI for $69.99 and federal for $82.99 right now

I can still load minor power factor 9MM cheaper than buying minor match ammo.

I ordered Mark7 universal powder check I hear the DAA doesn't fit on press between other dies but the Mark 7 does..

I use one shot on 9MM and .223 brass with zero issues.

Anyone using one of these?

Just pulled the trigger one.

Answer for you questions 1-3 are in his original post.

Are you shooting matches with this gun or just plinking?

How big are the groups is the squares on the target 1"?

Never heard of such etiquette especially sense not evreyone is on all the forums.

What's the benefit of the OLED?

Thanks

What kind of holster did you get?

Any problems with coating flaking off and sticking to comp on your PCC? I had this problem with Berry's and xtreme plated.

I will have to try this.

I use Hornady 55 FMJBT 25 GR H335 and get just under MOA out of my 18" 1-8 barrel. H335 meters great on my Hornady LNL press.

https://www.apextactical.com/smith-wesson/pistols/barrels

If not in a hurry you can back order form midaway for $200 cheaper.