dtuns

Has this ben replaced with the Redding NxGen Carbide Sizing Die?

You need 54 inches between the top of your bench/mount to the ceiling to fully open the hopper lid

I'm using TTI base pads and these fowlers and getting 25+1 in My M&P https://csrgstore.us/products/csrg-multi-platform-competition-follower-spring-kit

That amount would only matter if you were rifle bench rest shooter. Pistol no issues.

Don't email you need to call them and if you don't want to wait on hold you can leave a call back number and they will get back to you. I broke my case pusher my fault called to ask where I could by they sent me 3 new ones for free.

I also recommend these I had to shim 9MM and .223 shell plate up with one of each for .012" total thickness fixed a lot of the case pusher issues. 1 98055A513 1074-1095 Spring Steel Ring Shim, 0.2mm Thick, 70mm ID, Packs of 5 1 Pack 1 0 8.62 Per Pack 8.62 2 98089A513 18-8 Stainless Steel Round Shim, 0.1mm Thick, 70mm ID, Packs of 1

I went from LNL to X-10 got it running smoothly a lot quicker than it took on LNL. I recommend checking every screw and bolt and make sure its tight.

Those are some good results.

I also have both and love them and really liking the Overwatch precision triggers on mine. I also have apex trigger but think the Overwatch have less take up.

https://www.regulations.gov/document/ATF-2023-0001-0001

How big was the group?

That's interesting never scene that one.

Run dot on all my pistols.

I use one shot and leave it on.

I have both of these contraptions and they work but you have to use them regilarly.

The firing pin block is under the optic not the iron sight so you can remove with out issue. The firing pin block is only under irons on non optic ready models.

I have a metal and 2 competitor's love them. The competitor shoots a little flatter for me.

The 23 rd mags are over 140MM so not legal. S&W dropped the ball on that.

I tried my USPSA holster for the hell of it and it was hard to clear cover garment with that set up.

How do you like the battle belt version? I need one for mutli gun and thinking about trying this.

If you don't mind me asking what have you spent on parts so far? I'm thinking about going this route.

Mcmaster Carr

Brass prices looked good till the shipping calculated $85 for shipping of 5000 rounds 9MM brass.

It does shoot flatter than my 4-1/4 Metal.

The competitor isn't ported just has slide cuts. The slide weights the same as my 4-1/4 Metal M&P