KennyWiz

Thanks bud! I tried calling Mossberg but sat in hold limbo for 30 minutes. I sent 5 emails and they replied to none.

Hi, Looking to remove the top rail from my "former" SPX. What goes into the threaded holes after I remove it? Is the there an OEM screw? Can I get a screw somewhere else? Sent from my iPad using Magic

What choke did they ship the 24" with? Sent from my iPad using Magic

Thanks Sent from my iPad using Magic

Hi, I just finally got around to installing the 24" Mossberg barrel and a new Nordic extension. Issue I'm having is the shells are not chambering when I rack the bolt back, they just stay in the magazine tube. (Unless I rack it SUPER hard) I trimmed the spring a little longer than the recommended 16" past the mag tube. I trimmed it at 20" past because fellow shooters told me stories of how the 16" was too short and they had to re order a new spring. Should I cut it down to 16" past the mag tube as recommended, or should I have cut it even longer? Thanks

How far off are they? Thanks!

Any info on these??? http://gregcotellc.com/cart/index.php?main_page=product_info&cPath=97_130&products_id=592 http://gregcotellc.com/cart/index.php?main_page=product_info&cPath=107&products_id=841

115gr Thamks Sent from my iPad using Magic

Finally got some time to spend at the range. This is my 1st CZ and 1st metal framed pistol. I've owned mostly striker fired and ran an M&P Pro in IDPA and 3 Gun. Un boxed and and removed the LIBERAL packing oil. Field striped, cleaned, and oiled. Dry fired some with snap caps. Took it to the range and was VERY happy with the felt recoil, (lack there of). Found the point of aim/point of impact, (poa/poi), was "off". Not sure where the Custom Shop sights in. 2" poi low at 30ft, 1" poi low at 40ft, and .5" poi low at 50ft. Guessing it's sighted at 25yds? I am not a strong pistol shooter, so my next range trip will employ a rest before I adjust the sight. 30ft 40ft 50ft I was running ammo with Winchester primers and had 5 light primer hits through 200 rounds. Also had 1 fail to feed. Will try some different ammo, but, can this extended pin help as well? http://czcustom.com/SP01Shadowextendedfiringpin.aspx I'm not gonna worry about the FTF until I put a few more hundred rounds and different ammo through. Overall I am very happy with my purchase. I wanted a "turn key" competition pistol and that's what I got. I've read that the Custom Shop's support is quite good should any issue arise. Also, when I call, someone who works on the firearms answers the phone. Those two facts alone are the reason I went with the CZ over a Tanfoglio Elite.

Was looking around some more and found this: http://www.ebay.com/itm/180989117205?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 Anyone tried these?

Found 'em on their website. Have a large order of small, expensive parts in store. Thanks!

Thanks! Tried PM'ing you as I saw you post on many CZ threads but your PM was full. Thanks again!

Hi, I am a new custom shop sp01 owner. Are there mag extensions that fall within limited class specs? Thanks Sent from my iPad using Magic

What work are you looking to have done? Sent from my iPad using Magic

BTW Just picked up a SP-01 Target from my local gun shop. Ordered it last night and picked it up tonight, WOW. $1160 Threw some snap caps in and getting some time on trigger.