chipu12

plus one on the cobalt bits...but good quality ones not the $4 from Amazon, almost ruined my TS when snapped

what brand die you use for decapping? Had the same problem on a Lee/Egw under size i had to lower the decapping pin in the die.

plus one for the pyrex powder hopper, more consistent throws

...so what's a decent price for hard chroming a CZ?

so no backlash on the uniquetek powder measure? any other options budget friendly?

i know people that got more then one "pew pew" with a single trigger push around 30-35K so i changed mine at 25-30k just to be on the safe side, really crisp trigger with the new CZC hammer

why i'm thinking it will be well into the summer until realistic will see one for sale

not a slide bite but one of my "south paw" shooting buddy with an Sp01 was complaining about the protrusion of the slide stop digging in to his tight hand thumb

did you have to send the slide or just the bushing to CZC? thanks Chip

TSO in 40S&W, i bought four complete 140mm mags from CZC , a little bit pricey but i can use 21 rounds reliably in all four with no problems. One of my shooting buddies had two broken Taylor Freelance base pads on 40 mags after dropping them on the concrete floor a the range, no issues with the CZC on same floor.

really tight tolerances on the Uniquetek clamped tool head, i had to do the alignment procedure recommended by Dillon also tight the screws on the tool head with all 5 station filled and still have some crushed cases on station #1 if I'm cranking fast.

I would not recommended it,i had the exact same free play problem as described above, i used a piece of fine wire around the notch where the c-clip retainer goes on the threaded shaft to take out the free play, still not perfect but its ok for Uspsa loads. Chip

don't need it...but want one..or two...bad

nice to have items http://www.ebay.com/itm/Dillon-XL-650-SL900-Bearing-rotary-shell-plate-cam-follower-/222384485888?hash=item33c725f600:g:LpUAAOSw2xRYWc1c http://www.ebay.com/itm/Dillon-XL-650-and-SL-900-Performance-Improvements-kit-/221316500435?hash=item33877dcbd3:g:xNUAAOSwaA5WkuPn http://www.ebay.com/itm/Shellplate-Bearing-Kit-w-low-mass-detent-ball-for-Dillon-650-/191271651675?hash=item2c88adc95b:g:H-0AAOxyCbFTmJqs installed the above items and my 650 and now its smooth like silk, the only problem for the first two items is the really slow shipping(3 weeks) Chip

nice set up guys, maybe somebody can come up with some kind of optical sensor that can check for the powder level in the case...