rack&roll

Does this include FP retainers with a slideracker?

It's not hard to do, but at that price ($506.00) I'd just get a new 35! Then you have 2 Glocks!

If you go with the 35 slide, you will need to chage the ejector on the frame to a .40 cal. ejector. (non-bent)

Thanks for the replies!

Production legal? If so, are they available?

Thanks!

1) At "make ready" (in USPSA production division) is it legal to manually lower the hammer to 1/2 cocked position? 2) Will my SP01 mags work in the Shadow 2? Thanks for your replies!

Makes me feel better to know I'm not the only one who has brain blatraumations!

The CZ mag stripper works great with my SA Loaded Target 9mm.

Easy on a CZ 75 SP-01 Shadow, but not on my CZ 75 Shadow SA! Same problem...must remove the trigger bar. (sigh...)

any luck?

I will try all of these and see what happens. I'm also gonna try a tungsten guide rod with a 13# ISMI recoil spring. Thanks for the suggestions!

Drift rear sight to the right...problem solved.

Thanks guys. Until I get my reloading act together, I'm at the mercy of AAA and my local reloader. They don't do custom reloads for people as low volume as me. Maybe a lighter recoil spring?

I finally broke down and bought the new M&P 9L PC ported. I really like the gun, it's very accurate and the new triggers feel great! No need to Apex anything. Problem is...it works great with my KKM non-ported barrel, but has at least 4 or 5 jams per mag with the OEM ported barrel. AAA 115, 147 and my local reloader's 124's. It extracts and ejects the empty case but the next round gets hung half way into the chamber, at a slight upwards angle, with the next round in the mag slightly forward and touching the rear of the "almost" chambered bullet. I have to pull the mag to clear. Has anyone else experienced this with the new PC ported? Thanks for any feedback!

My experience has been that the lighter the spring, the less the accuracy and reliability. I use the 15# ISMI and SSS Tungsten guide rod in all my M&P's. It just works.

Thank you! Yes, that is the "fly in the ointment" so to speak.

I have an older (1st version) 9L, a Pro 40, and a CORE 5". I use the same 9L Bladetech holster for them all. They all fit the same.

There are only 4 small ports, as opposed to like 8 on the PC ported CORE. I don't see the competitive advantage? I do appreciate the feedback, though.

Can I use my magna-ported OEM CORE slide with RMR and non-ported KKM barrel on my 9L frame in CO division? Thanks!

Does this mean I can use my magna-ported CORE slide with RMR and non-ported KKM barrel on my 9L frame in CO division? Thanks!

Yes, I did try the #13, and had FRTB issues and poor accuracy. When I switched to the #15, I found the recoil was (is) just as manageable, very little difference in shot to shot recovery,100% reliable, and more accurate due to the barrel not unlocking too early. When I ditched the #13...my problems went away! I am certainly no expert, but this works for me.

I have the best reliability and accuracy with the ISMI 15# spring in all my M&P's.

Very nice...I like the stainless (?) slide.

YEEEEEEPPPP! My 40 pro mag catch wore out very quickly. Would drop a fully loaded mag (19 rds) from first shot recoil. I simply replaced it with a OEM mag catch.