bunt

It lined up, seems like the case was hanging on a very small edge on the inside of the metal bushing arm, by adjusting the wedge to over cam (if that makes sense) it makes it drop onto the plate

Thanks jmorris read your post over again last night and got it squared away seems to be working fine now. Loaded up about 600 rounds this morning. Thanks again for your help

The case drops from the case feed adapter (the piece you are talking about) and yes I have the slot in properly, into the case feed bushing. it hangs up at the junction of the bushing to the arm photo 181 on page 39.

Recently starting using a 650 with a casefeeded and am having problems with case dropping into casefeeder arm. The case drops into the case feed arm bushing but doesn't drop down onto the plate it hangs up on the edge of the arm, this is happening around 20 out of 100 times. It's a real PIA I have to watch and if they hang up i jiggle and push the case through the bushing into the arm. Slows my roll a little more than I like! Any suggestions on making the transition from the plastic bushing to the metal arm loading 9mm and using green bushing. Thanks in advance for any help.

Probably get Mr. Bullet a Feeder.

Yes have case feeder on the 650 and do 10,000 of 45 and 9 each per year,. Always thought the case feeder on the 550 would speed it up quite a bit.

I am debating as to what would be the best choice putting a case feeder on my 550 or a bullet feeder on the 650. I know eventually I will do both but wanted some input as to what you think would be more efficient. Currently have 550 set up for LP 45ACP and just got 650 will be for 9mm, load around 10,000 rounds of each per year. Thanks in advance for your support input.