freeidaho

IDPA.com has a members page that is searchable. You can indeed find out most whatever you want about membership.

First, let me type that I hold MDs in the highest regard. They and their close staff put their lives on hold for weeks at a time to put on a match! This however seems black and white if that is what actually happened. Shouldn't take a protest for an MD to throw out an illegal stage.

When the process works right, there is an SO application form that needs to be filled out by the applicant. It is sort of a shooting resume, and it asks for references of someone that knows the shooter, sponsors the shooter and supports the shooter becoming an SO. It also asks about local and sanctioned matches attended or worked and some other stuff. The SOI is supposed to verify the applicant's potential to be an SO. Not everyone is cut out to be an SO.

Absolutely correct. Sorry for the distraction.

This was covered on another forum. By rule, the mag can stick out up to 1" when measured at the front of the grip. Some G17 mags make this, others do not.

Wait. What? 5.6 Disqualification (DQ): Disqualification means the shooter may not continue in any part of the IDPA match, may not reenter in another division, and may not shoot any side matches. The shooter’s score will be reported as DQ. A shooter must be Disqualified for the following reasons: 5.6.1 Unsafe firearm handling as defined in the Safety Rules Section. 5.6.2 Receiving more than one FTDR during a single match. 5.6.3 Unsportsmanlike conduct 5.6.4 Violations of the Shooter’s Code of Conduct 5.6.5 Shooting at a steel target that is less than 10 yards from the shooter.

Videos or it didn't happen

Not too many of the 25000 IDPA members belong to BEnos, and even fewer are active in this thead. Just saying this is hardly a random sample of IDPA shooters, which it would have to be, for the results to be meaningful.

If/when you think you need an overlay to score an IDPA target, the benefit of the doubt goes to the shooter. Done!

The rules are simply the rules, unless you read them incorrectly. 8.2.2.1.7 All firearms legal in SSP are legal for use in ESP. This provision may be used for firearms that violate an ESP rule (for example, a firearm with a steel dust cover or rail over 3.25”) to still be used in ESP, provided the firearm meets all SSP requirements. 8.2.2.3.1 Steel dust covers and rails over 3.25” (82.6 mm) (as measured from the rear of the slide stop pin to the most forward portion of the dust cover or rail) are not permitted.

The points down areas of the target are not changing. So no issue with ordering targets.

CCP follows ESP rules and ESP allows this: 8.2.2.2.26 Slides with front cocking serrations, tri-top, carry melts, and high power cuts. So it is not allowing any ole serrations you can think of, but front cocking serrations, as on the side of the front of the slide are allowed.

Congratulations, you completely missed the point of Rowdy's and my post. If you have followed Rowdy's shooting rise, you note he has sought out consistent great preformances rather than hero and then zero. Hero and then zero is easy. Consistent great performances is much harder.

Rowdy, You have joined the ranks of the highest MAs and DMs. Those that choose to dance on the edge of a cliff, sometimes fall off. Staying back from the edge is a better long term strategy.

WRT bolded. I'm pretty sure the 2013 comments were public, but I don't know about the 2015 comments. That said, the announcement said this change came directly from the BoD. Of course they have the comments too. Thank you. I too have enjoyed shooting with you.