DULLYJAY

My 45acp's will shoot out my Kimber all day long, but it will not extract out my Para LDA. What am I doing wrong?

THANX 4 info. guys

Can I use pistol primers for a rifle load? Varget powder.

I got a squib round in my 1911 barrell 5" . How do I get this out. TIA

I got a squib round in my 1911 barrell 5" . How do I get this out.

THANX for all info.

G.G., can you please tellme correct way to crip in the the cal. stated above? It looks like we reload and shoot the same things.

Looking for loads you guys like. I have 110gr.SP. TIA

Just to put some holes in paper. Maybe for SHTF ammo, when the 308 runs dry

I have some 110gr SP bullets. How do you guys load for it? TIA

I loaded 5.2gr. of IMR Skor 700x under a 250gr lead 45acp. There was no load data for this in the IMR handbook. The load I was reading was for 45colt. Can I shoot this & still be safe? Whats your load for this powder,bullet if any? Shound I call IMR for info? I'm sure you can tell I'm a ROOKY! TIA

Yes, very new to it. Thanx for the replys guys. Learned alot by them,going to load some 45acp now. WISH ME DA BEST!

The bolt is swelled in the receiver. It will be some hard work to get it out to check. Good idea.

Yes, its a RL 550.

It started off good. Was shooting my loads for 308win. I'm know sharp shoot so 5 under a inch is good with three of them kissing. So I move on to shoot my A.R.. Getting about a five inch group with iron. Nice for me. So I get a FTE, so I clear the case out. Next shot. BOOM. Not the good boom. I kill my upper, & holosite. Split the top of receiver, long crack where barrel meets receiver. The bolt carrier is split so you can see bolt. Both sides off upper are puff out about a 1/4inch. So this is what I think happend. I miss a powder charge in the round that miss fired, so the primer push the bullet in the barrel. Next shoot, you know the story. So I'm not hurt,no body around me was hurt. It could of been real ugly. Now I have to replace a upper,but I learn a good lesson.

Just got 500 these bullets. I have some IMR Hi-Skor 700x powder in the deal.Whats your load for the both? TIA

THANX guys. Will try the above.

I'm useing Lake City brass with Win. bulk 55gr bullets. Not trimming.

I'm useing Lee dies. THANX.

My bullets are sitting loose in the case. If I tap the top not to hard the bullet will get pushed in the case. I'm not sure if I'm crimping correctly. How do I do this the write way? TIA

I'm useing Lee dies. Thanx for the reply.

I have a like proplem. My brass keeps hitting the rim of the sizeing die or the gets stuck on the deprimeing pin. I adjust the paper clip thing a few times. Can some one help here? I'm a rookie.