Thanks for the qhuck reply, I'll ck to make sure its not lead(I dont shoot lead) but it might be a build up of carbon. I did not think of that. Thanks again
Rob
I just found out today that my bullets are hitting my comp at times. A friend suggested reaming out the comp a little to prevent this. Does this sound ok??
Rob
Roger who works with Angus who is out of the country. Roger is going overseas for a week and he can help you when you get home. If its real important I could call him and perhaps get some from him. HIs # is 602-295-6301 he is leaving sunday am so better hurry
Rob
I have both of those presses and the downstroke is a bit had for my wife on either machie. For me I like the 1050 better for 38 super comp and the 650 is very nice in 40. If you plan on changing cal's I would look at the 650, its much cheaper to change cals. also like flex said use one shot a little befor you put them in the feeder and its much easier. also you might want to clean yhour sizing die once in a while.
Rob
Well I must say Doug is a man of his word. I got my gun back in two weeks and it was as tight as a swiss vault. I shot about 1k rds through it and all is very nice. I would recomend Doug Jones to everyone.
Rob
M-pro 7 is the only cleaning solvent I use on any of my guns from pistols to my 338 lapua. As for lube slide glide is the lube of choice for me now.
Also mobil 1 is not a detergent motor oil, it's synthetic aka no detergent. That is why it lasts so long. Trust me I used to work for mobil I know. fwiw I don't use it for anything.
Just my 2c's worth
Rob
The way I unserstood the question was (and I took this for granted) that the gun would be holstered. At this point I am focused on the target. If the gun is on table I would of course focus on the gun then. I really dont think there is any other way to do it. Unless your zen like