bubba04

Do you experience a side to side play with the case feed slide. It almost looks like it’s starting to bind as it returns to push a case in

I have chased the squeak down to the black device that pushes the casing into the shell holder. Anyone have any ideas of how to remove to clean? I have loaded about 10k rounds on it and it just started making a noise. picture below.

I have run approximately 5k through my beretta 92 without issues. If they get to 18 bucks again I will buy more.

I have done this more than once that's for sure...

How are you mounting the optics on your 92?

How do these handle being trampled on? Or is this something you don't walk on?

After using both mbf for win

Ended up going to mrbulletfeeder and wow it's worth the money. Thanks for all the feed back guys.

Thanks sir. I ended up m rearranging my space to fit press. I appreciate your feedback.

No doubt. I fully assembled it and didn't have any extras parts so when it wasn't working I started flipping through manual.... i panicked through trash and luckily found it stuck in a bag.

I couldn't find part. It was stuck in a bag In the trash. It makes a difference in if anyone is curious.

Thanks I just found that in the instructions. I guess reading this is a good idea...

What am I doing wrong!? What am I needing to adjust to get brass to drop down? The arm doesn't move enough to drop brass 100 percent of time.

Thanks i I saw that thread. I guess I should have asked if there is an appreciable difference in the different options. Sounds like no...

where are yall getting the bearing upgrade kit? Hitfactor or somewhere else?

Is the mrbulletfeeder die easier to set up than the hornady bullet feeder die? I find the hornady an absolute pita to set up for my coated cast bullets and am hoping that's not the case for mrbulletfeeder die... thanks

Awesome thanks! I wasn't using caps...

I couldn't get the acme code to work!? is anyone else experiencing this?

I have had good luck with sns casting, but I am looking at trying leatherhead. I have their 220s for 300 blkout and plan on trying their 9mm.

From the top of your table to case feed top is great total length 36 inches?

It's a pretty stupid short roof. I won't bitch too much because it is a dedicated room to me. to maintain 6" clearance as access above hopper it will leave the handle of the press at 42.5ish inches. I am assuming a bench height of 34.5 inches and press mounted directly to bench. My issue with with this is this is about 7 inches lower than my current rig up. ( I reload standing). if I can trim the case feeder as others have suggested I can better maintain the proper height for the press handle. This sounds like the best option for path forward. if I trim the unit then I will use a strong mount instead building the bench to the proper height, unless that's a bad idea.

My ceiling is at 79 inches so I am trying to figure out how high to build my new bench.

I appreciate the feedback. Thanks guys.

Great advice. How much tube did you remove?

I have not much ceiling space where I reload. I have the measurement for how much space is needed from bench top to the top of the case feeder. My question is in your experience how much space is required between the case feeder and ceiling to be able to load cases into the feeder.