RePete

When I shot PPC 40 years ago I was taught never to stage the trigger just a steady pull and follow through.

Good, a waste of time and effort!

The Rollsizer.com machine doesn't condition the rim whereas the CasePro100 does.

Dillon has always stated that lube is required. From their web site. For high volume users, such as commercial reloaders, law enforcement agencies, and high power or service rifle competitors, we also offer .223 and .308 die sets with a full-length carbide sizing die. Lubrication is still required, but the increased scratch resistance and die longevity of carbide are of great benefit to these groups of users.

Nothing new, Dillon Precision make them for .223 and .308 but you still MUST lube the cases.

I remove the trigger stops from inside the rebound spring because other shooters have had the pin break. I have installed a trigger stop in the trigger using the screw with the rubber tip, and it was a spongy feel. I do not use them anymore.

I wonder if this is what you are looking for?HE509T-RD-user-manual.pdf HE509T-RD-user-manual.pdf

Just use a little more lube than normal, not on the neck though.

SB dies are smaller in diameter and do size further down the brass. I have resized machine gun brass without issue other than they are a bit harder to pull the lever down, just use a bit more lube on the body - and eat more Wheaties! As for stepped brass and SP 45ACP, no issues other than making sure that you sort out the 45.

What Ben53 said. The brass is more than likely machine gun fired.

I used Hoppes #9 and just wiped them down. Easy peasy.

I my area it's G17/34, CZ's, Canik, 1911, P320, some revolvers.

According to SDM's site yes.

You nob Warren, I almost snort out tea when I read that. I had to laugh though.

I use Ready Tactical pouches and holster and think that they are the bees knees, but alsa they don't appear to make the any more. Purchased from Chris Patty.

JM has a clip where he uses a weiner fto simulate a finger when shooting. Not only does it cook the weiner but cuts/tears it too.

Very nice.

I installed them in my STI Trojan (45) and after 300rds they were toast, I took them out never to be used again.

^^^^^^^^^^^^This^^^^^^^^^^

All I use is Breakfree CLP for 25 + years and prior to that Hoppes #9 oil.

You mean this?

I bet that the brass was NT.

I can rollsize 9mm, 38SP, 40S&W, and 45ACP. For .223 and .308 I use SB dies.

Maybe, just maybe a little (alright a lot) spendy to chuck in the glovebox!

Why not send an email to the owner of Practiscore?