AHI

reduce your powder charge.

I had to have a pro seating die opened up in 38spl . This was to load 148 wadcutters seated flush . No matter how the die was adjusted it would start crimping . (this was a seating only die)

1 depends on the matches you shoot just shot a 5 stage match reconfigured belt 3 times. Mostly adding /removing shot gun shell holders 2 don't know most use a 014 Safari land holster. will you ever need a sling? If so The DA wont be ideal.

Most PCCs don't lock open. No need.

At one time the SD was offered in 22 Hornet/ 22 Remington Jet/ 22 Bee. Now from the angle of your picture it kinda looks like a powder funnel for One of those.

any markings on it? can we see the side view?

sizing / seat / crimp dies. they go under the tool head in the "body" of the press.

These is an adapter for the BMT.

NO neck or full length. Pick one full or neck. Most likely if you neck size for your AR. will become a single shot. (it will jam )

neck sizing is for a bolt gun

search feature upper right corner.

The older PM were built to tighter tolerances. As a general rule operate smother. More consistent drop to drop. The newer PM are the ones that leak and bind. I am not Shure what your problem is(cause).Your PM could just be worn out. Buy a new PM give it a try. Just thought of something their is a spot on the PM that you need to grease from time to time. At the end of this video.

Older version with 2 return springs?

Some brands or brass are known to stick in 9 mm revolvers. Star Line for example can /will stick in a S&W 929. So not uncommon . The steal cases sticking does not surprise me at all.

70% corn cob and 30% walnut is all I use. Add a little car wax if you need more shine.

fail safe rod installed and properly adjusted ?

After putting over 500 fmj/jnp through my 43X. Using a bore scope to make 100% sure the barrel was clean. It no longer leads with coated bullets.

Correct me if I am wrong. In production and carry optics. There is still a weight limit and gun must fit in the box.

Yes . could leave it at that search is your friend. old style return spring. smother more consistent return of powder bar. tape to take up space ( so it does not leak) Dillon use to have thicker spacers to stop the leak. Therefore preventing the leak that causes the sticking. just a few.

^ This^

124 HP are moving 1220fps average and group under 2 inches at 100 yards.

I have opened up several gauges because of this. Same as the XL gauge for 40sw. Just open up the hole for the bullet not the case.

3Gun PCC division shoots to 100 yards. The drop of 115s zeroed at 50 yards at 100 is about 3 inches . But fmjs are not accurate in my guns. 124hps work much better. Same drop.

1 FTF = Fail to fire 2 FTF = Fail to feed If #2 then yes OAL can affect feeding.