xdnok

It could be said that all brands have some failures, I have had good performance from RTS2 while others have not and they now have a "V5 hardened" version out that I use on a few guns and I have had good and bad experiences with Leopold. Even my latest Sig Romeo3 Max had to go back, but the new one is awesome and it has quickly become my favorite RDS.

I have only seen an SRO at distance and I hear great things about them, but I really like the features on my R3 Max 6 MOA, of course I'm an RTS2 fan as well so there might be a little bias there

Most range brass is good, however I usually stick to FC, Speer and Hornady brass for matches and the rest are for practice. In the past I have used new brass for major matches but honestly if you check over your brass and stick with brass that you know runs well through your gun you should be good without the added expense of new brass.

Springer Precision makes an adapter plate to mount the Romeo3 Max or RTS2, seems to work well on my Legion.

I put 2 V5 RTS2's on my S2's recently, replacing the DPP's I had on them previously. So far all is good and really love the BRIGHT 6moa dot.

Run the P10f it’s good to go! I shot Matt Hopkins P10f not long ago and was impressed. That said I love my S2 and my X5 Legion is just a tick behind the S2. Lots of good choices out there.

The gray guns trigger is an improvement over stock, slightly less trigger pull weight, a little crisper break and less over travel. The trigger face is actually a little narrower than stock and that helps the feel. Overall nothing drastic but nice upgrade.

Yes, this works no matter what. I have several S2's purchased that came from CZ Custom with a trigger job and it is so worth it.

I have had an optic go down at a major match before and a backup keeps you in the match as opposed to packing up and going home.

Have a Romeo 3 Max but it has a RTS2 mounting pattern and to top it off it is a little longer on the front so it may or not fit a normal RTS2 mount pattern. The mounting screws are 4mm instead of the normal RTS2 8/32 mount screws as well. Unfortunately the Legion only fits DPP and R1 pro pattern optics.

Yes there is plenty of room to make a cut for a CZ custom plate on the OP slide, it is a deep cut. Note how far the cut is into the CZ logo by the 9 x 19

Yes a 1 degree cut is needed to keep your optic in the center of its adjustment range. Yes I made the expense mistake of cutting the slide flat and ran out of elevation adjustment on the optic. Likely the best course of action would be to cut the slide for a Cz custom plate that can be swapped out for different optics, that what I did for all my S2’s

Random, at best. Have to admit I don’t go to a match for the prizes, my prize is how I performed at the match.

I would be interested