I am trying to figure out which type of powder to buy to reload
6.8 SPC
300 Winchester Mag
270 Winchester
I use a dillon reloading press. I found out the hard way that IMR powder does not work well with my press.
Any help will be greatly appreciated
Hi I am trying to reload 223 rounds with IMR-4198, but I am not getting consistent powder readings. I also getting powder dropping after cycling the press. Is it my powder bar? or is it the powder?
I am new to reloading and I have a 550B with Dillon 223 dies. I tried following one of the threads in this forum and I am more confused that when I started. Is there a step by step process to reloading 223 rounds?
The main point I gathered is that the cases need to be trimmed.
Any help on this matter will be greatly appreciated or if someone can recommend a good dvd that will walk me through the process step by step that will be great.
Thanks,
Oscar
I am new to reloading and I believe that I have a good understanding of loading handgun ammo. Now my next step is to begin loading rifle ammo. I have never done it and I was wondering if someone knows of a good resource that will help me get started reloading rifle ammo. I am pretty clueless when it comes to reloading rifle rounds. Any help on this topic will be greatly appreciated.
Hi Folks, I am about to begin reloading my first batch of 40 SW bullets. I am using Titegroup powder with Montana Gold 180 grain hollow point jacketed bullets. Does anyone have reloading data with this combination. I found a site that states the starting load should be 4.1 grains. Can anyone verify that this is correct?
Thanks
Hi I want to use Titegroup powder and I going to reload 3 different calibers. Does anyone have reloading data with Titegroup powder and the following bullets
380 auto .355 95GR. JHP
9mm Luger 124JHP
40 SW 165gr.JHP
I want to try using the same powder for all three calibers and I also want to reduce the amount of recoil with the 40 SW.
Any help with this will be greatly appreciated.