Glock XIX

http://www.brianenos.com/forums/index.php?showtopic=181618&hl=%2Bsmall+%2Bpowder+%2Bbar#entry2005105 Pretty good read on this page about the X small powder bar

The tubing OD is the same but the ID is different. The $14 tube is rated for 2,900 PSI and has an ID of 0.215 The $30 tube is rated for 3,851 PSI and only 0.183 ID. Higher pressure thicker wall tubing, It would be a tight fit in the high pressure tube. Nominal OD for a small primer is 0.175

Out of Stock , No Backorder 7/23/2013

Don't bother... "out of stock " already

There is a lot of "small primer" brass for 45 ACP. Are you sure all your brass is for " large primer " ? Assuming you were using LPP.

Me too. With the lock washer in place, i discovered the handle would eventually spin after a very short reloading stint so i took it out. The stock handle didnt have one, nor was there any slippage with it so i figured this one wouldn't either. 5K rounds later its still tight! Now if i could only keep the roller handle from backing out... I found the same thing,my handle would come loose after about 30 cycles. I removed the lock washer and now it stays tight. No problems with the roller handle

I put mine between the lip of the bushing and the O-ring, where it sets in the press frame. Fixed the problem right away.

They call it a PTX powder measure stop, Item # is 290049 it will run you about $8.00 + $4.75 for shipping. 1-800-338-3220 is the Phone #

I got mine last week, the invoice shows item # 290049. It will run you about $8.00 and $5.00 S&H.