sonja55

Brownell's makes a product called Cerrosafe. It is a low temp chamber casting metal that you can melt with a heat gun and use as you did the epoxy. Use a cleaning rod with patch instead of ear plug. If you do screw it up just reheat it and it will flow back out.

KT Mech LLC http://www.kt-mech.com/i_magpouch_carriers.html

I had the same problem on one of my rifles. The Match ammo gauge said I was good but every round I tried to chamber locked it up like a bank vault. Put the same ammo in a JP Match gauge and it was no go. Resized cases I bought were not resized correctly. I knocked the stuck round out with a G.I. cleaning rod.

If you buy the set from Dawson Precision they will give you a new front sight if it does not shoot to point of aim. If they do not stock the height you need they will make you one.

I zero at 20 yards. I would use whatever rear I liked and buy a Dawson front at the height I needed to zero it at 20 yards.

I put a Dawson adj. rear in a Gen4 34 today. A little metal off the bottom and it drove in with a delrin punch.

I have also seen the firing pin block spring in sideways cause the problem.

I have never seen one , but Wilson Combat made a adjustable that slide was milled flat and screws held sight on. The front screw in picture looks like the elevation screw hole.

I put one on my Versamax from a 1100 synthetic stock . Remington R3 pad , slipped in and holes lined up for screws.

Devils Hole / Havana name is Central Illinois Practical Shooters / CIPS on USPSA clubs page.

I am pretty sure Midwest has rules against shooting steel and drawing from holster.

Short Flat for me.

I shoot a Shadow in Production. I shoot it in Limited Minor with the 18 rd mags with extended mag pads.

Brownells 593-000-038WB 1" QD-100 Bases only, 10-Pak 5930000381" QD-100 Bases only, 10-Pak

Chillicothe Sportsmens Club www.chillisportsmen.org

8.6 states official paper and all pistol , rifle & shotgun steel targets. Not clay targets . Probably because you would owe the Host club a bunch of money for destroying their clay holders.

Blade tech DOH

11 LBS , 147' S @ 133 power factor.

Faxon Firearms makes one with your requirements.

Should have listened to me , not Kevin.

Springer is now showing base pads for the P07 / P09 platform.

With 8.5 LB spring and Extended firing pin, my 2 Shadows will reliably fire Federal primed ammunition only

JP. Great people and support.

I would call Don after 4:15 PM.

The Pro Bore tubes are for the Versmax. That is where I bought mine.