Hello to all of you.
I purchased a Full Size Steel .40 EAA WITNESS back in 2001. The first couple of years I did quite a bit with it, but the last couple of years i really haven't done anything at all with it.
I'm now again wanting to further presue this project. I'm looking for ideas and suggestions. The one big question I have is I'd like to add a scope mount. The problem is where EAA stamped the Serial number on the frame.
Most scope mounts I have seen would require me to Drill / Tap through the Serial number location, but I see so many Witness pistols with scope mounts. Has anyone else encountered this and what was the work around. ( or can u suggest a good left side mount, if single side scope mounting is adaquite. )
I filed for a variance with the ATF so that I could install a scope mount, but they said under no situations will they do that to allow me to change the location of my serial number. The mounts that EAA sells are intended to go on the bigger (cal) frame guns.
Yes I could just drill / tap 2 holes on the right side of the frame (and 4 on the left) so as to not interfere with the serial number. I don’t know…maybe. Ideas?
Is there anyway to reliablly tighten the Slide / Frame relationship?
So Ideas and Suggestions for me would be greatly appreciated.
Here's a photo and a brief Discription of what I have done so far:
It is a Full-size all Steel European American Armory 'Witness' chambered in the .40sw. Pictured here sporting a
5.25" threaded barrel with a triple-port compensator. This gun has been a fun project piece, and shoots amazingly well and accurately. It features Houge wrap-around rubber grips, complete tuning and action work, extended Safety and magazine release, all new Wolff Springs throughout and a new rear sight from Precision Sights International, LLC. ( Model TR-90-TA ??)
This gun is completely lubed and protected by Militec1 metal conditioner.
Recoil Spring has been changed to a 16# Wolff Spring with an XP Firing Pin Spring. ( Factory is 14# )
Hammer Spring Has been Reduced to a 14 # Spring. (Factory is 16# )
Barrels / Barrel Hood / feed ramps have been polished as well as other bearing surfaces. (( Trigger bar, Trigger Bar Plunger etc ))
All Magazines have +10% XP Wolff Springs & 1 has a +5% XP springs...for a performance comparison
Mag Lips have been dressed and all followers were refitted & modified.
Thank you for your time,
-Martin :-)