Spanners

+1

Sorry.. have reread. I skimmed the 1st post and saw 1200 there.. computed that into 1050.. as I'm ordering parts for my 1050s etc and have it on my mind. You dont have a 1050, thus you dont already have one...... Either way, that or a M die will work Try a normal resizing die in the last station if you can get it to fit and back it off a turn or so and see what the burr is like.. should wipe it out

See below pic stolen from Mr Bullet Feeders Page The backup rod has expander section in it. (middle part with arrow) Just install it in a station after your trimmer I havnt trimmed up any of my rods

Just run the backup rod/die in the swage station Its basically a M die

Nope, needs to be milled

All the Dillon setups use a milled tool head

Thanks I thought as much however Brassaholics post I quoted shows a link to a 1ph motor (PW copy) and a VFD... very confused.. lol Does anyone have a link to a 3ph replacement for the PW motor - ie to use the existing gearbox

To confirm, you're running the PW copy single phase motor on the 3ph output of the above VFD? How have you got it wired?

I'd have to check, but if I recall correctly,using 45ACP/308 plate, magnum powder die and 50AE? funnel

Powder funnel marked AK ie whats used to load 7.62x39

AK powder funnel

Thanks 1/16 is about 62 thou, I can measure over 250 thou!

I have a 1050 which until last week I thought was normal - after using somsone elses, I find its far from normal! There is alot of play in the crank/key/link which I;m working through with Dillon Tonight I was changing tool heads and noticed that the machine has ALOT of rotational play in the tool head when at the top. The tool head is tight, the whole shaft is turning - the pin #11009 appears to be when the play is - whether bearing, pin, linkarm or crank arm - need to look further. I think I may have got a friday special - only had 2000 rds though it but seems excessively loose For those with 1050s, could you please measure the rotational play with the tool head at the top, from the primer tube would be a good reference. I think I may have got a friday special - only had 2000 rds though it but seems excessivly loose everywhere Thanks

Fix here http://www.brianenos.com/forums/index.php?showtopic=162927

Have you got the right buttons for the conversion?