Mike L.

Send them an email and ask: gssf@glock.us. They are usually quick to respond.

The 45 is basically a 17/34 frame with a 19 top end. To my knowledge the frame is no different between the 45 and 17/34 and is interchangeable. HTH.

1. The TTI +5/6 will work great for the G17 mags. 2. A G34 holster will work for a G19 and even a G17. A G19 holster will not work for the other guns if the muzzle end is closed off.

I wound up picking up a used Benelli M2 Field with the 26" barrel. I am looking at getting started in 3 gun and am going to get a tube extension (plus 7) and larger bolt handle. I plan to upgrade as needed as I go on in the sport. I did notice the stock is a standard black synthetic and not the Comfortech. Should I look to get a Comfortech stock? Thanks in advance.

10-8 and Sevigny both offer black rear/ fiber-optic front sights for the G34 Gen5 MOS.

My understanding is the Gen5 replaced the Gen4, that is why the Gen4 was discontinued. The Gen3 is still made for the California market as that was the last generation on the roster. The California market keeps the demand for the Gen3 in place.

What about Gen 4 and 5?

P80 is what they were sold as outside the US. Glock 17 was the US model.

They came out with a V4 plate to replace the V3.

I run Ready Tactical pouches and holster. I've had them many years.

Sorry, I meant the blue label discount coupon cerificate. I knew it wasn't a certificate for a free gun. Thanks.

Does anyone know long before after joining GSSF you are able to get a certificate? I let my membership expire as they stopped holding matches that were semi close. I recently moved to an area where the matches are closer proximity. That being said I would get a G34 GEN5 MOS.

Welcome. We just relocated to Battle Ground, WA. It takes 50 posts to be able to post in the Classified section.

CHPWS mounting plates: http://www.chpws.com/product-category/reflex-red-dot-mounting-plates

How stippled is it? Production allows stippling in certain areas as I recall.

I was informed by the folks at Sevigny Performance the sights for the G17 and G19 will work on the G43. Once they developed sights for the G43 the ones for the G17 and G19 were the same. This is in regards to the Warren Tactical and Sevigny sights.

.235? You may want to check that as the Warrens are listed with .185, .215 and .245.

What is the height on your current front sight?

What height is your current front sight? Did you order the .215 or .245? If you purchased the .215 you need the .245. Good luck.

Welcome, that's the attitude to keep you in for the long haul. It can only get better from here. Good luck.

My gen 3 34 is poi/poa with .215. There is no guarantee as you will have to try one and see.

Welcome to the forums!!

I have a couple T.H.E. s/s guide rods for my 17 and 34 and the fit and function is outstanding.

Have you contacted Glock?

Iirc the pre-travel is adjusted on the trigger housing, which is not visible externally.