Jump to content
Brian Enos's Forums... Maku mozo!

pau605177

Members
  • Posts

    41
  • Joined

  • Last visited

Contact Methods

  • Website URL
    http://

Profile Information

  • Gender
    Male
  • Location
    Jefferson, Ohio
  • Real Name
    Paul Schray

Recent Profile Visitors

690 profile views

pau605177's Achievements

Looks for Range

Looks for Range (1/11)

  1. Which disconnector did you choose? Any recommendations for use with stock hammer to achieve best reset with minimal issues?
  2. Are you referring to this one? https://czcustom.com/cz75-disconnector-shrt-f-b.html
  3. Is the disconnector the same on both Shadows?
  4. Got it. I was referencing appendix D7, which apparently has not been updated. Thanks
  5. Optical/electronic sights are "permitted", not required.
  6. I have 617 with the aluminum cylinder I wouldn't mind replacing with SS. Just curious, Why did you replace the cylinder?
  7. I'm not familiar with the logo....just curious, who built it? What caliber?
  8. So, what happened to the 8 shot minor revolver proposal?
  9. That's pretty cool, you can use the same mags for L-10 if you choose to.
  10. I also have been using Tripp 10mm System mags. I don't think they are really a 10 round mag. The product packaging label says 9 rounds. I know they start with a ten round body and shorten it up to fit the box. Are you guys getting 10 rounds? Reloadable? Paul
  11. Just curious, who did the conversion?
  12. What mags are you running in that thing?
  13. Actually this barrel went in a high mileage gun. The barrel went right in. No fitting required (feet of course). It went right in! Not loose though. No cuts on hood length required. Chamber should be good. We all know Wil Schuemann knows what he is doing. Free bore however may need a little something to accomidate longer rounds. Wil recommends .200" of free bore. This is for a standard length 9mm round. Does anybody lengthen the free bore for 9mm major loaded out?
  14. I am installing a new Schuemann 9mm AET barrel in my 9mm major. I have two questions. These barrels are already finish chambered. What diameter should the freebore be for .355 bullets? It seems the freebore is a little snug. Both factory rounds and my own loads require a little push to fully chamber. The bullets clearly show drag marks from the freebore area. I would think you might want .0005 -.001" clearance in this area?? Second, the rounds I load are around 1.190 OAL length, should the free bore be lengthened by the same amount I have increased the AOL of the cartridge? Thanks Paul
×
×
  • Create New...