DEADEYE

no i did not it was kind of a impulse buy at a local LGS...

Will that fit w/o modifications? Sent from my SM-G970U using Tapatalk

What do you want for the extra mag well? Sent from my SM-G970U using Tapatalk

What do you want for the extra mag well? Sent from my SM-G970U using Tapatalk

Hayes custom.. Sent from my XT1635-01 using Tapatalk

I have been told the Remington mags will work just have had the time or $$ to buy any. I found a guy on you tube who works with the Rock Islands and supposedly some of his stuff will work. Sent from my XT1635-01 using Tapatalk

Nice fiddleback to the maple stock awesome work..in this day and age of plastic stocks I appreciate a nice slab of wood...

Ah Sent from my XT1635-01 using Tapatalk

MSH ? You lost me..

Joe4d let me know if you you come up with the, mag well, etc as a starting point..

Mags are another issue do you have a source I ain't spending 120.00 for. Mag. Sent from my XT1635-01 using Tapatalk

Thanks let me know.. Sent from my XT1635-01 using Tapatalk

Thanks I was looking in the manual and saw a multi piece extractor..

I can see 30 bucks for mags I ain't spending 100.00+ for mags no way in hell. It's a limited. Sent from my XT1635-01 using Tapatalk

Did I buy a [emoji882] here out if date piece of crap with no support available? Sent from my XT1635-01 using Tapatalk

I know that.. Sent from my XT1635-01 using Tapatalk

I had a 16.40 limited follow me home (impulse buy) from a local gun shop yesterday. I'm a sucker for 1911 platform guns... Where does one get spare mags, mag base plates and maybe a mag well I did see mags on gunparts.Com. My first 40 cal what grain coated cast bulletts I have unique and 700x on hand is there other powder choices I should have..I shot SS a few years back then life and kids got in the way of me shooting I recently moved to the twin cities and want to get going again and didn't want to beat up my dads old 1911 anymore...questions recapped below.. mags. magwell coated cast bullets weight powder choices brass sources

My brass just doesnt get real shinny if I only use one or the other if I use both then it gets better i will try the mineral spirits once and see....

dumb question I have walnut and corn cob media use both one vs the other or one for a coarse then other for fine cant seem too find and answer?

I am looking at a change too I have used Unique and 700-x but am looking at Solo, Clays or Ramshot. My cartridge mix is 45.acp, 38 special and 44 mag and trying to find a one size fits all is hard as keeping 5 different powders around gets ridiculus?

You would need to test the hardness of both bulletts to see there may be the difference in the equation right there,,,

The bevel base vs flat base thing in regards to leading is more due to burn rate of the powder and harndess of the bullett more than the shape in my experience.

Either method will harden the bulletts somewhat but hardly worth the effort for pistol bullets four our purposes. Besides water and molten lead is a bad combination...

You can add 50/50 bar solder or get tin in rolls Harbour frieght sometimes has it cheap. This gets you close to Lyman #2 whcih for all but really hot magnum loads this is plenty hard remeber too hard is no good either as TL alluded to you will lead up when the bulletts are to hard to obturate the base to seal the gases off behind the bullett.