MJ13

Thanks, I told him to just use it with 6. Do you who sells the 7 or 8 round magazines?

My son brought over a PPS he pick up in 40 cal. Really hard to load the magazine. It’s supposed to hold 7 but I can only get 6 in it. It has 6 holes on the indicator side but I’m only at five. Maybe my hands are just too old.

Thank you, I’ll give them a call.

Where are the best places in Phoenix to buy practice rounds of 9mm and 40 cal?

Just finished installing the new ZEV adjustable trigger. Polished the safety plunger added a drop of oil to the slide and barrel. Used a small dab of Clenzoil grease to the connector. It runs great. Thank all you guys for the great information.

Thanks LT I’ll give them a call and see if they can help. The gun is older and had older ZEV slide and parts but I couldn’t see any markings on the trigger shoe . Appreciate your help.

Sounds like a good place to start.

Any idea how to get a set screw and maybe a new safety spring?

Does anyone know who makes this adjustable trigger shoe? It is in a Glock 34. The bottom screw is missing from the left hand side. I am hoping if I can identify it I can contact the maker and get a replacement set screw and an Allen wrench to fit it. It seems to work OK but the safety lock spring seems very weak.

Thanks guys. So it is a Gen 3.

Thanks Eli very helpful.

Here it is.

Mag release is aftermarket. But I’m guessing it’s Gen 3.

The gun came with a ZEV slide. Texture is the G3. No back straps.

Does the number 4 stamped inside the glock frame mean that it is a Gen 4? I was told the gun was a Gen 3.

Thanks for the heads up on NDZ

This is a used 34 and I’m new to Glock. The trigger pin has some very sharp edges on both sides . I am pretty sure the divots should be smooth. Do they all end up with sharp edges?

Do do most people just change out the plastic guide rod for a metal one and keep the flat spring?

GigG is Timney one of the best drop in triggers?

Braxton1, I’m replacing a broken ZEV slide with a similar slide, It has the posts. It looks like you install the RMR directly to the slide cut and use the blue locktite. Does that sound right to you?

1911Jerry to you get over to Glockmiester? It’s at 15225 N Cave Creek.

Great info guys. My trigger is terrible so I’m going to try polishing and then change to Wolff springs for striker and trigger one at a time. The trigger is very heavy and you can feel a lot of drag during the entire pull.

Need to replace a couple of pins on Gen 3 Glock. Should I go with OEM or stainless pins?

I like the Johnny Glock YouTube videos. He rambles a little but I like his personality.