tanks Posted July 13, 2017 Share Posted July 13, 2017 I recently purchased a 1050 set up for 40 S&W. I also bought a Mr. Bulletfeeder set up in 9mm as I had a .40 on my 650. I moved the .40 plate and the dropper assembly from the 650 to the 1050. Dropper assembly works perfectly, drops a single bullet and places it in the case mouth without issues. However, the Mr. Bulletfeeder with the .40 plate is NOT flipping the bullets at all if they are nose down. I am at a loss, I even transferred the same cardboard inserts from the 650's bulletfeeder thinking that might be it. Called DAA tech support, but they are out today. Any suggestions are welcome. I played with the angle of the Mr. Bulletfeeder but have not really seen a change. I don't think there were any parts on the Mr. Bulletfeeder assembly itself other than the plate I needed to move. Link to comment Share on other sites More sharing options...
Sarge Posted July 13, 2017 Share Posted July 13, 2017 youtube has several MBF videos where Rick guides users through most every potential problem. Whenever mine acts up, which is rare, I go straight to those videos. Link to comment Share on other sites More sharing options...
cvincent Posted July 13, 2017 Share Posted July 13, 2017 Move the nose guide inward. Loosen the wingnut, move it till the noses drop down. Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
tanks Posted July 13, 2017 Author Share Posted July 13, 2017 Thanks I found Rick's video on the bullet flipper. I must have gotten lucky on my first Mr. Bulletfeeder as I did not have to deal with it before. Now, to get back to adjusting Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now