Springer Precision HK VP9 Grip tape

[Loves2Shoot]

http://shop.springerprecision.com/category.sc?categoryId=46

Align and press in the center of the grip, lightly heat with a hair dryer until you see it get soft and then stretch around the grip. The contoured grip requires you to stretch the tape around it and this design should work with most of the combinations of grip panels.

[KJFpdx]

Thanks for posting! This may be just what I've been looking for. Right now I have an ugly quickie skateboard tape job and it's peeling off.

[kranzjdw]

Awesome!!! How does it fit around the back, any chance we can get a pic?

[Loves2Shoot]

Awesome!!! How does it fit around the back, any chance we can get a pic?

I do not put tape on the back. It prevents me from adjusting my grip on the draw and needlessly eats up my hand.

[kranzjdw]

Ic.... That does make since, I've only has stippled grips so I'm new to the skate tape.

[KJFpdx]

Hello all:

My grip tape arrived pronto. Other than the obvious (unload and ensure the firearm is clear), what should I do? Clean the grip and just stick it on? I was planning to wipe it down with 99% alcohol and let it dry.

I remember reading something about using heat, but I don't remember where I saw it. It did not come with instructions. Thanks.

EDIT: Duh, never mind. I see the instructions at the top of this thread. It's been a really rotten week so not quite up to speed.

Edited October 27, 2014 by KJFpdx

[stuey93]