Jump to content
Brian Enos's Forums... Maku mozo!
SPRSkip

Super 1050 primer recovery

Recommended Posts

jmorris   

The one I built is pretty much the same but I made it from 1x1x1/8" angle that I trimmed down and welded to some 3/8" steel tube.

1.jpg

Share this post


Link to post
Share on other sites
SPRSkip   

Anything that gets the job done and not have to mess with that little plastic bucket. I started with 3/8 then stepped up to 1/2 so catching the primers was pretty much bullet proof for me.

Share this post


Link to post
Share on other sites
hrt4me   

Anything that gets the job done and not have to mess with that little plastic bucket. I started with 3/8 then stepped up to 1/2 so catching the primers was pretty much bullet proof for me.

do you plan to make and sell any of these as well?

Share this post


Link to post
Share on other sites
SPRSkip   

Anything that gets the job done and not have to mess with that little plastic bucket. I started with 3/8 then stepped up to 1/2 so catching the primers was pretty much bullet proof for me.

do you plan to make and sell any of these as well?

Yes they are $15 plus $5.35 shipping

PM sent

Share this post


Link to post
Share on other sites
hrt4me   

Anything that gets the job done and not have to mess with that little plastic bucket. I started with 3/8 then stepped up to 1/2 so catching the primers was pretty much bullet proof for me.

do you plan to make and sell any of these as well?

Yes they are $15 plus $5.35 shipping

PM sent

darn, I should have just had you add one of these to my order for your case feed fix...

Share this post


Link to post
Share on other sites
Anyone close to me have a RL-1050?

Not sure I am close but I have a d RL 1050. I am in Minneapolis St Paul area in Burnsville Minnesota. What do you need?

Share this post


Link to post
Share on other sites
SPRSkip   
Anyone close to me have a RL-1050?

Not sure I am close but I have a d RL 1050. I am in Minneapolis St Paul area in Burnsville Minnesota. What do you need?

I was looking for a machine in my area to see if my primer recovery bracket would fit, or what modifications would need to be made to get it to fit the RL 1050.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×