I switched to Cci reluctantly due to supply and have loaded 40,000 pistol rounds and had no reported issues yet. The seem to feed through the RF100 primer filler better as well. I may be a convert now. Sent from my iPhone using Tapatalk
Bought 3 of these 1000 watt dehydrators. Work good but at least 4hrs as they only go to 175deg. I need a higher temp option for a lot of brass processing. Sent from my iPhone using Tapatalk
I use Fast and Friendly brass shell plates and have zero upward flex on plate when priming. I have set of a few primers in this station. Not worth the risk blocking it in my opinion Sent from my iPhone using Tapatalk
I just worry about leaving it on the loaded ammo and causing it to attract grit of dust. One shot won't effect primers or powder will it? Sent from my iPhone using Tapatalk
So those of you that wet tumble and lube when loading, what lube do you use and what process do you use to remove it? I was considering using Hornady one shot and leaving it on.(very small amount). Thoughts? Sent from my iPhone using Tapatalk
Ya I think I might have to custom build a force air drier. I would like to have something that keeps them moving as well. Sent from my iPhone using Tapatalk
So I bought a case gauge for 300 Blackout from EGW and am loading 147gr FMJ. OAL is good but the will not gauge. When I use my Wilson cause gauge the are perfect. What's the deal? Did I just buy a very expensive paper weight? Sent from my iPhone using Tapatalk
Fast and friendly won't ship there shell plates to Canada and Mark7 only stocks there 9mm plates and I'm looking to by two .223 plates for my dillon 1050. Sent from my iPhone using Tapatalk