Jump to content
Brian Enos's Forums... Maku mozo!

f2benny

Classified
  • Content count

    114
  • Joined

  • Last visited

About f2benny

  • Rank
    Finally read the FAQs

Recent Profile Visitors

410 profile views
  1. P320 X5 Thread

    ^that is basically where my rear sight is too Sent from my SM-G930V using Tapatalk
  2. P320 X5 Thread

    The gun functioned fine with 115g factory ammo which is what most consumers would shoot. Sent from my SM-G930V using Tapatalk
  3. P320 X5 Thread

    I may buy a shorter front sight. My rear is cranked up pretty high. Sent from my SM-G930V using Tapatalk
  4. P320 X5 Thread

    My gun wouldn't run with a 14lb spring on my powder puff 147 load. I had to get a 13lb spring. Sent from my SM-G930V using Tapatalk
  5. P320 X5 Thread

    Anyone find that the guns shoots quite low? I had to really crank the rear sight up. I might replace the front sight... suggestions appreciated. Sent from my SM-G930V using Tapatalk
  6. Cover garment

    A vest is nicer than a shirt because if you carry your Barney mag and light in the pockets they help the swing of the fabric on the draw and reload. Sent from my SM-G930V using Tapatalk
  7. Fluted Chambers

    If Wilson is hawking them they'll be required Sent from my SM-G930V using Tapatalk
  8. P320 X5 Thread

    Yes they just came out last week Sent from my SM-G930V using Tapatalk
  9. P320 X5 Thread

    Springer comes through again. 13lb spring in. Sent from my SM-G930V using Tapatalk
  10. Sig P320 X5 Case Separation and Extractor Loss

    Possibly. But I can't count the number of guys using n320 and 147s for minimal pf loads. Sent from my SM-G930V using Tapatalk
  11. How long should a fibre optic rod last?

    Link to video? Sent from my SM-G930V using Tapatalk
  12. P320 X5 Thread

    Another pleased RHT owner Sent from my SM-G930V using Tapatalk
  13. P320 X5 Thread

    I have a 13 in my fs. Runs fine. Sent from my SM-G930V using Tapatalk
  14. P320 X5 Thread

    First observations of my x5. First it will not function with my 130 pf 147 grain loads. It stove piped repeatedly. I took the Springer guide rod and 14lb recoil spring out of my fs and installed it. It was too short but it worked for a couple mags. The sights were off by 6 inches too high at 10 yards. Windage was fine. The trigger is decent. Not much better than my stock fs curved trigger. I compared my x5 to another x5 which was equiped with a pelt trigger installed in house by GG. I was surprised to find that the GG trigger seemed a bit mushy in comparison. It was definitely lighter but did not feel better overall to me. Sent from my SM-G930V using Tapatalk
  15. P320 X5 Thread

    That's what I thought. Sent from my SM-G930V using Tapatalk
×