Dustint21

No opens shipped this week that I know of. I will try to find out when the next set of open guns is planned to ship before I leave today. Thanks Dustin

That is not what we normally see with a broken safety. If one breaks it is most likely to break in the middle where the two safeties meet. Please contact our warranty department so we can fix this. I apologize for the inconvenience. warranty@stiguns.com or 512-763-3922 Kind Regards Dustin

From the pic you sent it doesn't look like a chip. It looks like something made contact with the bottom of your slide. We have been using the same guy for hard chrome for years. He is one of the best in the business. We will know more when we get it back in house.

Lmao you guys are killing me!

This is the correct answer.

It comes stock with a 14lb recoil spring.

Thanks all! Dustin, I dimly remember the Aristocrat manual in the box. Thus far, I've only had one session at the range. Clearly I have some more homework here to do here, I still want to replace the front sight, but it's more for visibility at this point. Before I do that, I'll look more at the rear sight. Just another reason I love this sight. Please let me know if you have any other questions. Dustin

The Target Master isn't your normal sight setup. This formula does not work. The rear sight is taller than most of the typical 1911/2011 sights.

The Target Master has the Aristocrat rear sight. Have played with the screw on the right side of the rear sight? It will raise and lower the whole rear sight. You will have to back out the three set screws on top of the sight also. This sight was designed to do exactly what you want to do. There is no reason you should have to replace it. If you replace the front sight you may run into issues with having enough adjustment. I'm not sure if Dawson offers a front FO that is tall enough, but that would be the first place I would call. Dustin

I would think we would still see a few more go out before that. I know one of the gun smiths has 4 at his bench as wee speak.They should go out within the next week or so.

Hey guys. I know there are open guns being hard chromed now. There is usually a 2-3 week turn around. Im not sure when they went out. I will try to get more info today. For those of you who are having issues with the lighter loads these guns are fit and then hard chromed. They will be a little tight at first. After a few hundred rounds they should start to eat the lighter stuff up no problem. If you for some reason are still having an issue contact us and we will do whatever we can to help. My fist hard chromed STI was a steelmaster and I ran 600 rounds through it before it was 100% It was frustrating but worth it in the end.

Call warranty 512-819-0656 or email Randy@stiguns.com. We will fix the issue. Sorry for your bad luck. Thanks Dustin

My best advise would be to send it back to the custom shop here at STI.

I find it very hard to believe that the DVC will not accommodate longer OALs like the Edge. Maybe Dustin can clarify for us? There is no geometry change between the two pistol that I am aware.

I only deal in domestic sales. I would contact your dealer/importer for better info. Sorry I don't have more info for you...... Dustin