rcc96

Placed order on Thanksgiving when they ran the 20% deal, after several phone calls and emails my order arrived last week. Customer service SUCKS...

Take a foam ear plug and cut a small disk off of it insert between hammer and firing pin. I Dry Fire with a full mag of dummy rounds and DO NOT CHAMBER a round never had a problem even with extended firing pins.

Sight tracker is legal in L-10....

Thinking about doing a sight tracker on a SS 40 any experiences? Thanks. RCC

Jay its on a 40... Also looking for a case pro.... ANYBODY?

Tino glad yours is working out,I did do a whole bunch of reading and research before purchasing this one and felt it would be a good addition unfortunately mine hasn't worked correctly from day one. rcc96

Well after a year several calls to Dillon,damaged cases,constantly replacing shell plate adapters and constant mis feeding on every reloading session I have given up on this aftermarket case feeder. I have three 550s and think Dillon is by far the best just this application to the 550 IMO just doesn't work. Best of luck. rcc96

Recently purchased a Para holster block for my race master holster and find the weapon to be very loose,you can rock the nose at least a 1/2" up and down and the weapon feels like it wants to fall forward out of the holster. Lock works just very very sloppy ... Any experiences? Thanks. Rcc

Recently purchased a Para holster block for my race master holster and find the weapon to be very loose,you can rock the nose at least a 1/2" up and down and the weapon feels like it wants to fall forward out of the holster. Lock works just very very sloppy ... Any experiences? Thanks. Rcc

Matt did two 6" slides for me at the time good turn around,I did have him reblue the slides before returning them...If I had to do it again I would have kept the slides in the white and have somebody else do the refinish...

MSH..ISMI 17lb 13 on the recoil..dont forget extended firing pin,100% for me.

Once a year ...call Beven he will give you some good information on magazine compression cycles etc.

Looking to refinish my 2011 Edge in NP3 / NP3 Plus thru Robar and would like to hear of any experiences you may have had with Robar and NP3.. Thanks. Rcc

Looking for some ideas to mount a 2"abs shute which would collect the finished round,dropping them into a bin underneath my loading bench. Any suggestions / Any pictures? Dave

Danny / Nghthwk both of your suggestions dillon also recommended…Nghthwk I have been doing the same... at this Dillon is sending some replacement parts out which I hope will resolve this issue.. Will report on the replacement parts .. Anybody else ?