poopshooter

is this wear normal? i think it may be leading to extraction/ejection problems im looking at the side of the breechface oposite the extractor hook

i got some help locally, all set now thanks

when i got the gun the pin block safety was stuck in the depressed possition i have tried poking back out thru the pin channel with a very small stiff wire but it will only drop down less than a 16th whne i try to get needle nose on the extruding nub well its just not quite enough material to get a tug anyone seen this or have an idea that may help me get it fixed? thanks -Craig

147 grain ibejiheads.com 3.3 grains of N320 I tried all the different weights and settled on these, I’ve burned about 30k with great satisfaction

ya that, or your a pussy. one of the two.

cant wait to see that bad boy in person, looks good.

i know a 9mm afc will load a .40, but your orig post has it the other way...not so sure...

Plastic guildrod

Hoppes is your friend! Saves them factory mags too. They tend to get the speckles if you dont keep um wiped down.

humm...where is my mag gauge...

anyone know if there is a us source for this smaller style 75/sp01 magwell that they sell in europe?

I'm shooting on Saturday, anyone driving down from the New England area that may have room for a hitchhiker with gas money? private message me if you may be able to help me keep from having to withdraw. Lost my way down

Hey guys, I’m aware that if i try this i will take a hit in round count. but I’m going to do it anyway for continuity. What combination of magazines, extended pads and guts do you recommend for getting capacity and reliability in my SMALL FRAME CZ 75. i will be merging a shadow and 75b sa .40 to get the set up as it will run in Lim.

what do you think would happen with a can of spray silicone from the hardware store?

im getting a new mag relase i think mine is wearing out already.