tk4

Is the key lock spacer needed on the m&p 9? Doesn't seem like it would do anything and I can't find it

Thank you for the options to try. Should swapping slides not be a factor. They used to sell OEM slides, so I assumed they were able to just drop in to a frame.

Swapping out slides seems to make things worse.

I have a few guns that seem to be setting off primers sufficiently, but unfortunately those slide are not optic ready.

I have several M&P 9s with the Apex both 1.0 and 2.0. I have one with the Timney Alpha. I prefer the Apex, but it seems the Alpha may be a little more consistent setting off primers. Even with Federal primers I get occasional light strikes with the Apex triggers. Are you all finding a difference in primer ignition, Apex 1.0 vs Apex 2.0 vs Timney Alpha? Or does this just very gun to gun? Before I needed an optic I shot 2011s and never had this problem.

My full size mags won't drop free from my 9c 2.0. The 15 rnd mags fly out. Is this normal?

Do you have it on a 2.0 compact? I assume it will work with full size magson the compact without any specific baseplates???

I need suggestions for a magwell for a M&P 2.0 9c. I was looking at Floyd's magwell, but it says not to remove it. I would like to be able to remove it and use it with standard 15rnd mags whenever I want to.

Norsso has a guide rod and 12 and 14lb recoil spring combo for $70, but I was hoping to just get a spring.

I am running a 135gr hollow point loaded with 3.3gr of CSB1 powder. It is a lite load. I have one P365xl that runs it just fine and one that doesn't.

I need a reduced power recoil spring for my p365xl. Where can I get one? Any recommendations on spring weight and where to get one is greatly appreciated.

Which attachment do you use/suggest? I generally prefer a medium drop (about 1 inch). I like the Blackhawk medium drop. It might line up properly to bolt on, but it might not.

I've done 3 of these semi fit Apex M&P barrels. I'm happy with the first 2. The accuracy is very good on them. On the 3rd one I think I was starting to figure out the fitting process a little better. It is more accurate than any of my 3 custom 6 inch 2011 guns.

I need suggestions for a uspsa holster for my 5 inch M&P with a TLR1 attached. Hopefully one I can get inside of 2 weeks. Thank you

Looking to get a PCC trigger recommendation. This will not be a competition gun. Reliability being the 1st priority Price 2nd Trigger pull 3rd, but something better than a mil spec trigger pull. It will be used in a QC 10 GSF lower.