AZReloader

You might check your primer punch. The punch itself should sit below the level of its housing. I have had to replace my small primer punch twice now. When the punch itself does not retract properly it will maintain contact with the underside of your primer wheel and inhibit it from turning smoothly.

Look over GunBroker and you should find what you want.

I prefer FMJ over Berrys' or Ranier's. Delta Precision is my preferred vendor.

Recently I picked up some corn cob and walnut media at the Dillon's store. They had them marked wrong. You may have picked up some walnut since that is a finer crush than their corn cob.

+1 to the EGW undersized die

I have loaded over 6,000 rounds with PD 115 gr FMJ bullets. I use Power Pistol 6.0 grns with them and find it to be a very accurate load.

I agree. I toss S&B into my recycle bucket.

Using the Shell Sorter is the fastest and best way I have found to separate out brass.

I like Precison Delta's bullets myself. Precision Delta

Here's another website to help identify headstamps ATFE Headstamps

I toss IMI brass as I have had issues with it feeding in my Sigs in the past. No problems anymore.

I use the EGW undersized dies on both 40 S&W and 9mm. It has been so nice being able to reload and shoot brass that has been fired from a glock without case buldging problems.

Dillon has replaced several decapping pins on my 650. No questions asked. They should do the same for you.

Independence brass has been nothing but problems for me. I toss it into my salvage bucket.

Power Pistol works quite well in .40 and 9mm. I have used it in .45 with good results.