StealthyBlagga Posted May 28, 2017 Share Posted May 28, 2017 I am looking to add a very short (ideally 3/4" long) single-port compensator to my 4.25" M&P9.I also want it to match the profile of the 5" Pro slide so I can use the same holsters. Of course, I will need a threaded barrel, but the focus of this thread is what COMPENSATOR options exist. I have looked at the Carver, but the shortest option there is a 2-port which is about 1/2" too long. Can anyone suggest any other options? Link to comment Share on other sites More sharing options...
jcc7x7 Posted May 28, 2017 Share Posted May 28, 2017 Look at EGW, most stuff is for 1911/2011 but if you call them , they usually go out of their way to accommodate Link to comment Share on other sites More sharing options...
Part_time_redneck Posted May 28, 2017 Share Posted May 28, 2017 (edited) Good luck in your search. I used to shoot a Glock in open. I had a SJC 11 port for major and the Carver 2 port for steel challenge. Like you stated, the Carver 2 port is still around 1 1/4 long. As far as I know it's the smallest one offered. If I were you, I would phone Bobby Carver and / or Steve at SJC directly. Both are great guys and would love to help. If there is an easy way to get where you want to be they can point you in the right direction. Edited May 28, 2017 by Part_time_redneck Wording Link to comment Share on other sites More sharing options...
StealthyBlagga Posted May 28, 2017 Author Share Posted May 28, 2017 I contacted Bobby - he was very responsive and gave me some good info on his compensator. I will look at SJC and EGW. Link to comment Share on other sites More sharing options...
Rugerglock Posted May 28, 2017 Share Posted May 28, 2017 https://tbrci.com/product/tbrci-mandp-micro-comp/ Take a look at this comp Link to comment Share on other sites More sharing options...
gixxerjunky Posted May 28, 2017 Share Posted May 28, 2017 Tbrci and strike industries are the only smaller comps I have seen I believe. Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
StealthyBlagga Posted June 2, 2017 Author Share Posted June 2, 2017 I have ordered a Carver 2-port and will see if I can make it work within my size constraints. I will post the outcome here. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now