Ruger LCR-X 3" Barrel sight picture, point of aim & POI

[Livin_cincy]

I picked up a Very gently used Ruger LCR-X 3".  The front sight is white and fixed with a fully adjustable rear sight. I can shoot with both eyes open.  

 

I shot consistantly low.  I did adjust the rear sight to raise it.   But I still seemed low.   I only shot 50 shots.

 

I seemed to shoot the 158 grain bullets better than the lighter 125 grain bullets.  

 

My sight picture was centered and flat across the top like in the manual.

 

I am wondering if I need the bottom of the white flush with the bottom of the rear sight.  Thus elevating the gun.

 

Ideally i I would like a 6:00 hold. 

 

I have read read that the trigger is unique and it is me doing it.   I dry fired extendively before going to the range.  So I thought I had the trigger figured out.

 

The recoil is very mild and controllable to me.  The nice grip is the reason I suspect.

 

So has anyone else been down this road ?

 

 

Edited May 12, 2017 by Livin_cincy