Sign in to follow this  
Followers 0
tha1000

Ghost 360 bullet out pouches help??

6 posts in this topic

I ordered 3 mag holders, two plain, one with magnets. The bullet out pouches on the two plain pouches are not drilled out for the rubber washer/spacer. The one with magnets is.  I am assuming that they should be drilled out to fit the rubber space in. Can any one confirm?

 

pouch on left is the one that has the magnets. you can see that the other one is not recessed. 

 

 

IMG_2274.JPG

Share this post


Link to post
Share on other sites

And for the love of Christ, how do you get the bottom magnet off?

Share this post


Link to post
Share on other sites

I use the same pouches, i will check when I am at home. 

Share this post


Link to post
Share on other sites

Thank you, but no need. 

 

Its apparently a redesign. The non-milled hole is the new style. 

 

As far as removing the bottom magnet, I had to hold the nut to keep it from turning with a big flat head screw driver. 

Share this post


Link to post
Share on other sites

You are correct, I have the redesigned pouches, not milled. 

 

Ghost requires a bit of tinkering sometimes but so far no complaints about the quality. But those tensionscrews....

Share this post


Link to post
Share on other sites

Posted (edited)

tha1000 did you get these to work? I was told that the lack of the milling is a defect. The recess is needed for the rubber washer which is (I think) necessary for the pouch to ratchet.

Edited by firewood

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0