dwc_sig Posted March 18, 2017 Share Posted March 18, 2017 Morning, Newly Purchased Matte Stainless CZ75 B: installed CGW 5SAO trigger (removed disconnector) installed CGW 80005 Ring Hammer Kit adjusted sear as directed so safety works. however, i have encountered the following issues: - when racking slide the hammer doesn't usually reset correctly (will occasionally) it will follow the slide back to half-notch (if that's the correct term) -flipping safety from on to off can cause cocked hammer to drop - releasing locked back slide with slide lever causes hammer to fall to half-notch would greatly appreciate any input, suggestions as to cause(s) and/or how to troubleshoot the problem(s). thanks in advance. David Link to comment Share on other sites More sharing options...
kneelingatlas Posted March 18, 2017 Share Posted March 18, 2017 I suspect the sear spring is not in right, you said you removed the firing pin block, did you remove the lifter or switch to a pre-b sear? Link to comment Share on other sites More sharing options...
dwc_sig Posted March 18, 2017 Author Share Posted March 18, 2017 i haven't remove the firing pin block. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now