Tripod Posted February 28, 2017 Share Posted February 28, 2017 You guys that build a lot of open guns what is the correct back angle relief for the comp and slide. I see written often it is 1 degree but have measure several open pistols of late all which run great with thousands of rounds through the pipe. The angle on the slide muzzle varied from 0.7 to 1.25 degrees. Oh and Joe Chambers that Black Mumba open gun you built and talked about in the open pistol forum is awesome. Link to comment Share on other sites More sharing options...
ScottieShootz Posted March 1, 2017 Share Posted March 1, 2017 always had it written 1 degree, then hand file to final adjustment gap. Link to comment Share on other sites More sharing options...
tyler2you Posted March 1, 2017 Share Posted March 1, 2017 The Yavapai slide fixture is also set up to cut a 1 degree angle. Link to comment Share on other sites More sharing options...
RIIID Posted March 1, 2017 Share Posted March 1, 2017 The angle depends on high the barrel is fit into the slide, 1 degree is a good starting point. Rich Link to comment Share on other sites More sharing options...
ltdmstr Posted March 1, 2017 Share Posted March 1, 2017 As Rich stated, it depends on the barrel fit. Higher lockup is going to result in a greater angle at the muzzle. Best thing to do is fit the barrel, measure the angle, then machine the slide and comp to match. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now