Let's see some pcc's

[scooterj]

20 hours ago, sbpt1911 said:

Nice! Did you paint some of the parts, like the KNS side plates? If so, what paint did you use?

Yes, I used Duplicolor automotive touch-up paint. It holds pretty good and can be removed easily with a can af carburetor cleaner. 

[Garmil]

Here is mine that I just finished. 4lbs 12oz

[MikieM]

Very nice. I like it.

That's the weight as we see it there? An optic would add a little bit more.

[Garmil]

14 minutes ago, MikieM said:

Very nice. I like it.

That's the weight as we see it there? An optic would add a little bit more.

Thanks, Correct hoping to keep it under 5 total.

Edited February 24, 2018 by Garmil

[sheepdog566]

Just finished mine...Ordered a bmiller carbon fiber magwell and need a taccom buffer.

[Photon]

Nice looking setup

[MikieM]

Just finished this a few minutes ago.

10.5 inch Faxon with Taccom extension. This one is legal (weld over pin).

KAW Valley bolt, 5 ounce buffer with 308 carbine spring. NFA spacer.

NFA lower in Magpul FDE, Thunder upper in same. SI 60 degree safeties, Raptor CH. 

Holosun red dot.

Taccom CF handguard cut to 12.5 inches.

Magpul MOE stock and grip.

Hiperfire 24 with curved trigger.

Taccom mag well.

Odin extended mag release.

Weighs 6 pounds 1 ounce.

 

 

Edited February 27, 2018 by MikieM

[hittman21]

Boy there is a lot of good looking iron on here. Makes me want to get in to PCC .