67rschev Posted December 9, 2016 Share Posted December 9, 2016 On the downhill side of my continuing quest for the best SAO trigger job on my Stock 2 . Anyone have ay pictures of correct form on welding up a sear cage ? Whare to put a couple fitting TIG spots and on the legs ? I get around .5 to 1mm creep due to cage movement . I know to most of you that would be a laughable amount for how you use your Tanfo , but I'm just tinkering . Link to comment Share on other sites More sharing options...
johnbu Posted December 9, 2016 Share Posted December 9, 2016 Contact ARy about getting a bolo. Link to comment Share on other sites More sharing options...
kgil275 Posted December 10, 2016 Share Posted December 10, 2016 Here is an old post that has a wealth of info. Link to comment Share on other sites More sharing options...
67rschev Posted December 10, 2016 Author Share Posted December 10, 2016 (edited) ARy You have PM kgil275 Thank you very good read . Think I would TIG a spot and then grind for fit before I would use an epoxy . All though the extended hammer pin pin supporting/loading the searcage is an ingenious idea and solution that I will look at closely ! Guess I've been away from centerfire pistols for a while , and have gotten a bit spoiled and used to the Bix'n Andy and Flavio Fare' in my bench guns . The Larry's Gold in the Xesse and Sig Trailside bullseye rimfire guns is a phenomenal trigger also . Edited December 10, 2016 by 67rschev damn autocorrect Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now