Brian04rs Posted June 27, 2016 Share Posted June 27, 2016 I got a smoking deal on a Cmc large pin trigger and am wanting to use it on a dpms 308 small pin lower. Question is are the hole locations in the same position? If that's the case I can drill and ream it to the large pin size. Have checked online for prints and have came up short. Any help would be greatly appreciated. Link to comment Share on other sites More sharing options...
kurtm Posted June 27, 2016 Share Posted June 27, 2016 (edited) Yes you can. I have done it for a lower that had the small pins wallowed out. Drilled it bigger so the colt large pins were a very tight fit and all was well. Edited June 28, 2016 by kurtm Link to comment Share on other sites More sharing options...
Brian04rs Posted June 28, 2016 Author Share Posted June 28, 2016 Excellent it's going in the haas tomorrow??thank you Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now