ToneSurfer Posted November 21, 2015 Share Posted November 21, 2015 I've had an M&P 9mm Pro for about a year now. Probably close to 8,000 rounds through it. Last two matches I've had the magazine drop out when firing. The first time I chalked it up to me not seating it all the way, perhaps. But it happened again within a few days. I have never had this problem before, ever. I number my mags and it was using two different magazines. I compared my Pro and my other gun, a FS 9mm (which also probably 8,000 or more rounds through it), and the mag catch on the Pro definitely had a bit of looseness in it that the FS did not. When first inserting the mag, the catch would move forward (toward the trigger), a bit before it would begin it's outward motion and then snap in place. I swapped the parts between the two guns and will give it another go. Just curious if this is a "common" problem. Link to comment Share on other sites More sharing options...
Domineaux Posted November 21, 2015 Share Posted November 21, 2015 Never had a problem, but I replaced mine with an extended metal release from LF Arms and it has worked wonderfully: http://www.lf-arms.com/M-P-Extended-Length-Magazine-Release-p/mpextmr.htm Link to comment Share on other sites More sharing options...
EchoMan Posted November 21, 2015 Share Posted November 21, 2015 Yes - Same here after about 7000 rounds using a Costa Catalyst Extended. The edge of the metal mag catch showed wear and finally the corner tip curled down enough to prevent proper mag seats resulting in misfeeds/jams. I like the Costa so I just replaced with same. And, I'll anticipate better this go-round. Good luck. Link to comment Share on other sites More sharing options...
shutr Posted November 28, 2015 Share Posted November 28, 2015 Same problem here, just replaced it with a Springer mag catch. hopefully that will solve the problem. Link to comment Share on other sites More sharing options...
JupiterAdam Posted November 29, 2015 Share Posted November 29, 2015 Similar to my experience - likely due to lots of dry fire mag changes. http://www.brianenos.com/forums/index.php?showtopic=215917&hl= Link to comment Share on other sites More sharing options...
rack&roll Posted December 2, 2015 Share Posted December 2, 2015 YEEEEEEPPPP! My 40 pro mag catch wore out very quickly. Would drop a fully loaded mag (19 rds) from first shot recoil. I simply replaced it with a OEM mag catch. Link to comment Share on other sites More sharing options...
Nemo Posted January 25, 2016 Share Posted January 25, 2016 I'm using the Springer but don't have too much mileage on it yet. Very inexpensive solution though; the factory mag catch is $2.50. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now