Would like input from anyone with confident expertise on how deep the swage rod should be on the 1050. I cut a few cases (these were purportedly surplus mil brass with crimped primer pockets but I've found most in this lot actually were not crimped...I deliberately bought them from on online vendor so I could use them to set up my swaging station properly. Oh well.
The first few pics are with swage rod set a bit low, the last 2 are with it set a bit deeper. Which is correct/best, or what change do you recommend?
<iframe width="480" height="360" src="http://s1182.photobucket.com/user/darkrayz1/embed/slideshow/"></iframe>
Thanks
Quirk