Search the Community
Showing results for tags 'drop'.
-
I have an STI Trubor Open gun with a very light trigger pull... It's almost identical to my two STI Edge Limited guns, except that occasionally the hammer doesn't drop when the trigger is pulled... It seems to happen most often after racking the slide to load a round... It doesn't happen often... Last night I shot four stages without it happening, but it did happen once on unload and show clear... When the issue shows up... I pull the trigger and it feels like the safety is on... If I release and pull the trigger again, the hammer drops... not good... Not sure what could cause that... Maybe not enough pressure on the left leaf of the sear spring?
-
Took my wife along to the Johnson 3 gun match this past weekend and now I am no longer getting a new shotgun for myself, she wants one. The budget is going to allow either a pretty much stock Beretta 1301 or Stoeger M3000 worked over into the P3K when the design is finalized. These 2 guns are picked because they are: 1. The 2 I was already looking at for myself. 2. Reliable and budget friendly. 3. Not heavy guns. This leads me to a few questions. While not terribly recoil sensitive, is the 1301 gas system going to be noticeably softer shooting than the inertia M3K when both are properly fitted and have good recoil pads? I have already read Patrick Kelley's article on shotgun fit and have applied it to my current shotgun. She has handled both guns in stock form but not shot them. Currently holding a 1301 she has to turn her head almost sideways and scrunch down to even sort of get on the sights. The stock needs to drop a good bit and some cast off be applied to even get her close. The long LOP of the stock M3K make other adjustments irrelevant to start. Between the 1301 and the M3K, which has more adjustment for drop and cast or will they both be about the same? My plan is to get either shotgun and the shim kit and attempt to properly fit it before she ever fires the gun. LOP will be cut to 12.5 inches with recoil pad installed. This will hopefully allow me to correct pitch with shims as well cast and drop while still maintaining a shorter LOP. I'm just guessing that proper LOP will come out to between 12.5 and 13 inches based of stock adjustments made to shotguns when I was growing up. My shotgun now has a 13 1/4 length of pull which is far to long for her. Any advice on this plan would be greatly appreciated.
- 14 replies
-
- shotgun fit
- drop
- (and 6 more)