Hey everyone,
I have a Shadow that is exhibiting light strikes with 13lb mainspring, stock firing pin and CGW reduced firing pin spring. On close inspection I noticed the firing pin is not protruding very far out where it contacts the hammer. Is this normal?
While I don't have the best micrometer skills I can put some numbers out there. Stock FP is about 2.470 and from the back 'shelf' (where it contacts the stop plate) to the end where it contacts the hammer is .135, with the pin installed in the gun the back end stands out and proud by only about .020... which does not seem like much.
I have the extended pin that I will fit soon enough but I would like to hear y'alls thought and maybe measurements.
Thanks!