Search the Community
Showing results for tags 'bench'.
Found 4 results
-
How tidy do you keep your station and bench? I’m curious about dust, spilled powder, debris, etc. Say on scale of 1-10 with basic mile markers below. 10- Immaculate- Intel could make chips at my bench. 7.5 Very clean. Frequently dust and always collect spilled powder even if it’s a single granule. 5 Moderate. Clean every few sessions or if dust / powder accumulates. 2.5 As- needed to prevent major accumulation...don’t feel the need very often. 0- Meh. Time is for shooting, not housekeeping. I’m in my garage and also do wood work there so dust is an issue more than spills. Curious what you guys do...
-
Would you rather set up your bench in a large uninsulated detached garage or small basement closet? Relevant context: -I live in the mid Atlantic so temps range from 0 - 100. However, I’m hearty...not too sensitive to hot and cold. -Basement area permits bench of only 40 inches wide by 30 inches deep. -Newby 650 reloader. -Not a huge volume shooter. Reloading mostly for PF and reliability. -I have children who crawl so I’m a little paranoid about lead safety. Buying bullets that are plated or coated. Would tumble outside in any event. -Not a ton of air circulation in basement. -Good neighborhood, so theft from garage isn’t much of a concern. -Anti-Gun neighborhood, so I’d feel some anxiety if kids are over to play or someone visits with garage door up. Opsec in basement would be much stronger. I’ve changed my mind a few times and am curious what you guys think from years of accumulated wisdom!
-
I'm building my reloading bench prior to the arrival of my 550B w/ Strong Mount and want to be sure I don't have a bench support where I need to put a mounting bolt. Should the Strong Mount be attached flush with the front of the benchtop? What is the bolt pattern dimensions? I plan on a stand-up bench and am 5'-6" tall. I've read that the handle should be at shoulder height. What is the distance from the bench to the handle with the Strong Mount? Thanks, Heli Av8tor
-
I'm going to be purchasing a Dillon 550B. This will be my first reloading press. Instead of reinventing the wheel I figured I'd ask more experienced reloaders for advice on a reloading bench setup. I have enclosed photos of my 3 car garage, which holds 3 vehicles, so I can't take a bay. Currently I have my workbench in the space between the two car portion and the one car portion. Initially I was going to bolt the 550B to my workbench. Drawbacks to this is that everything will be visible when I have the garage doors up (often, as I live in the desert), dust/dirt from being in the garage, loss of workbench space and collateral damage to equipment while working on other projects. Along the wall is a row of storage shelves and a closet which is hiding rakes, shovels, brooms, etc now. I was thinking of building a small dedicated reloading bench in the closet and adding shelves to the back wall. The closet's interior dimensions are 36" wide, 24" deep and 93" high. Advantages: everything in one spot, can keep door closed/locked, don't have to put everything away between sessions, cleaner, more protected. Disadvantages: more cramped, although I can put the tumbler on the workbench when in use. Do you guys think a table 36" wide x 24" deep is doable? I'm right handed, should the press (when I get it) go in the middle or to one side? Any other thoughts at this point? Again, this is all new to me, so I'm open to suggestions. Thanks for your help! Trvlngnrs
